Torque is the real limiting factor. You can always gear up or down for whatever you’re working on, but at the end of the day you need enough torque to get the work done. And a proper milling machine needs A LOT of torque.
There are no “typical values” when you’re running a mill or lathe. You could look up “speeds and feeds”, but that’s really just a table that you plug into an equation to figure out how to set the machine. It all depends on what you’re doing and what you’re doing it with. Drilling a hole with a high speed steel drill bit is going to be a bit different than drilling it with a carbide spade, and all that is going to depend heavily on whether you’re trying to run through titanium or tin. You need to fine tune running “x” bit through “y” material for a “z” sized cut.
Essentially, this is the knowledge that separates skilled labor from manual labor, and machining is (was, RIP cnc button pushers) skilled labor.
At the end of the day for most metal machining you’ll need between 50hp and 100hp to be up to modern standards. If you want to get that through steam or electric motors or whatever that’s up to you
Torque is the real limiting factor. You can always gear up or down for whatever you’re working on, but at the end of the day you need enough torque to get the work done. And a proper milling machine needs A LOT of torque.
Can you give me some typical values, maybe? That would be a big help.
There are no “typical values” when you’re running a mill or lathe. You could look up “speeds and feeds”, but that’s really just a table that you plug into an equation to figure out how to set the machine. It all depends on what you’re doing and what you’re doing it with. Drilling a hole with a high speed steel drill bit is going to be a bit different than drilling it with a carbide spade, and all that is going to depend heavily on whether you’re trying to run through titanium or tin. You need to fine tune running “x” bit through “y” material for a “z” sized cut.
Essentially, this is the knowledge that separates skilled labor from manual labor, and machining is (was, RIP cnc button pushers) skilled labor.
At the end of the day for most metal machining you’ll need between 50hp and 100hp to be up to modern standards. If you want to get that through steam or electric motors or whatever that’s up to you