No Nintendo is saying that anything using the key files is illegal

Fosscad.org has a good zip archive, I still see some from time to time on printables aswell.

Since the best available firmware is open source I don’t see any way of imposing limits on it.

The printer itself doesn’t even know what it’s making since it’s reading directions one by one, so any limits would need to be implemented at a slicer level, which are also basically all open source (at least any worth using).

The only way I could see it working would be mandating that all printers sold in the US come with software checks against it and be non reflashable, but considering a new driver board that would be able to drive 95% of printers is about $25 it is nothing more than screaming into the void.

No infinite money sink. Started by printed some upgrades for my printer, now i suddenly have 3 that can waste plastic at significantly higher speeds.

If you don’t think you need ANC you’ve never experienced good ANC, even the best passive noise isolation won’t quiet down the sound of a full cafeteria or bus.

No wired iems will never be obsolete, but I will just be leaving them at my desk where the downsides over wireless are less.

They tried to ban phones in the hallways and cafeteria, while only providing online schedules which could change at a moments notice.

Ban went into effect, no one complied. Ban was lifted next week.

Got the fans in my pc turned up higher than needed just so i dont heat the coil whine.

I had swimming as a subject from 7 years old in school here in NL.

It’s cycling here as well in the Netherlands. Additionally in my circles: starting a campfire.