I have tried freecad a number of times to replace solidworks as a critical piece of closed source software in hardware development toolchains. I have always struggled. Yesterday someone spent an hour with me at a makespace saying… “FreeCAD has a different way of doing this/try realthunder branch/use symmetry condition/delete all conditions that coincide” … it has been worth years of trying alone. When I started solidworks the reseller gave me a week of training - this is often why complex FOSS software gets a reputation for being clunky, because alone you will spend ages hunting a GUI button in a complex interface.

TLDR: Go outside, go to makespace or a FREECAD conference - meet other people who use open source software - its much easier to use/learn from others than alone.

Thanks for your response - I think that we agree. My point was just that your post was about being decent, then you randomly dunk on a group.

It’s not that your personal experience isn’t representative - I think that there is a contingent of privileged people who feel left out by progress towards a level playing field. That sort-of makes sense, right? There are also strong echo chambers pushing those people towards radicalization. I suppose I’m asking you to feel empathy for these, very privileged, victims of a society that doesn’t know how to engage with them. Egalitarianism has to bring everyone along - I don’t know if that can be done.

It’s usually straight white american males too.

Can I ask why you wanted to add the last sentence? You might be right, statistically, but the tone sort of implies that you judge the group rather than the behavior. (apologies if that was the joke).